1-1/4 inch Pinned Back Button Supplies

This item contains everything you need to make 1.25 inch buttons in our Model 125 ProMaker Button Machine. The shells and pinned backs are made from heavy duty recycled US steel. The mylar is 1.629 inches in diameter, 3 mil thick plastic that protects your graphics and gives the buttons a professional glossy finish. These refill supplies are compatible with the ProMaker Model 125 Button Maker.


Works with:
Model m125 Button Maker


*The mylar on American 1.25 inch button supplies is a little smaller and thicker than the metric counterpart. They work ok in non-US machines, but will likely have a higher failure rate than if you used 32mm sets. if you have a badge a minit machine or a machine that came from Amazon or Ebay (Chinese made) the 32mm supplies in the metric section will probably work better for you.